SDCP Menus

Security Configuration Options

The Security configuration options group is described in Chapter 7, Security.

Control Branch

The Control branch of the Top-Level menu allows you to manage hardware and software functions, such as speaker volume, reset, busy out, and firmware download. The 3821Plus modem has the additional hardware function, Service Line.

To access Control from the Top-Level menu, press the key until Control appears. Select Control.

(Modem Status) MDMA mdmb mdmc

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Call_Setup

 

Status

 

Test

 

Configure

 

 

Remote

 

Security

Control

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Reset

 

Service_Line

 

 

 

 

 

or

 

 

 

Make_Busy

 

 

DiscServLine Download

 

or

 

Code

RemoveMakeBusy

495-14846

Reset

Reset causes the modem to stop operation and perform a complete program restart. The modem begins the power-up test sequence that ends with the Top-Level menu displayed on the LCD. Configuration options stored in an Active (Saved) configuration area are copied to the Active (Operating) configuration area.

Make Busy or Remove Make Busy

The Make Busy function is available only on 3821-B1 models.

The Make Busy function forces the modem off-hook so it cannot answer a call. This is often used with PBX systems to permit the busy out of a PBX port for rotary or hunt groups.

WARNING

To not violate FCC and DOC regulations, this function must only be used behind a user's PBX.

Service Line or Disconnect Service Line

The Service Line function is available only on 3821-B1 models.

The Service Line function allows you to switch a specific 3821Plus modem installed in a COMSPHERE 3000 Series Carrier from normal dial operation to service-line operation. This switch only places the modem on the service line. For a connection to be established, you must still use the normal dialing methods as described earlier in this chapter under Call Setup Branch (page 3-9).

A service line is an extra dial line connected to a COMSPHERE 3000 Series Carrier. This line is normally shared by up to eight 3821Plus cards (24 modems) installed in either Slots 1±8 or Slots 9±16. However, by daisy chaining the service-line connector of one Network Interface Module (NIM) to the service line of another NIM installed in the same carrier, you can permit all

16 cards (48 modems) to share one service line. The service line can also be extended to other carriers in a cabinet. Only one modem may be switched to the service line at a time. For more information regarding daisy chaining of modems to the service line, refer to the COMSPHERE 3000 Series Carrier, Installation Manual.

3821-A2-GB20-40

January 1999

3-47

Page 73
Image 73
Paradyne 3821PLUS manual Control Branch, Security Configuration Options, Reset, Make Busy or Remove Make Busy