Paradyne 3821PLUS manual BusyTone Detect Enable Nxt Enable Disable

SDCP Menus

Table 3-6

(2 of 4)

Line Dialer Configuration Options

BusyTone Detect: Enable

Nxt Enable Disable

Busy Tone Detect. Sets the modem to monitor for Busy Tone (Enable) or ignore Busy Tone (Disable).

This configuration option is normally enabled; however, if the modem receives false busy tones, this configuration option can be disabled and the modem ignores all busy tones.

The factory default is Enable.

AT command equivalent is Xn.

``,º Pause Time: 2sec

Nxt 2sec 4sec 6sec 8sec 10sec 20sec

Pause Time. Determines the number of seconds the modem pauses when it encounters a comma (,) in the dial command string.

NOTE: Although SDCP selections are limited (2, 4, 6, 8, 10, or 20), values set by the AT commands can be displayed as 0 to 255 seconds.

The factory default is 2sec.

NOTE: The default and permitted settings of this option are country-dependent. See Appendix H.

AT command equivalent is S-register S8=n.

NoAnswer Timout: 45sec

Nxt 45sec 30sec 60sec 120sec

No Answer Abort Time-out. Determines the number of seconds an originating modem waits before abandoning a call attempt when no answer tone is received.

NOTE: Although SDCP selections are limited (30, 45, 60, or 120), values set by AT commands can display from 1 to 255 seconds.

NOTE: The default and permitted settings of this option are country-dependent. See Appendix H.

AT command equivalent is S-register S7=n.

Fast Disconnect: Disable

Nxt Disable Enable

Fast Disconnect. Allows the modem to disconnect immediately after receiving a disconnect command from a local DTE or its own diagnostic control panel.

Disable ± The modem follows its normal disconnect sequence by issuing a cleardown sequence or long space disconnect. This is also known as a graceful disconnect since the other modem receives advance notice of a disconnection.

Enable ± Use this setting if the DTE requires that the modem be made available as soon as possible after receiving a disconnect command.

NOTE: This abrupt method of disconnecting may cause problems with the remote modem, which may interpret the disconnection as an error instead of a valid disconnect.

The factory default is Disable.

AT command equivalent is S-register S85=n.

3821-A2-GB20-40 January 1999 3-31