Paradyne 3821PLUS manual Miscellaneous Configuration Options, RemAccssPasswrd Nxt

SDCP Menus

Misc

The Miscellaneous configuration options determine specifics for various functions, including network management parameters and remote modem access.

Table 3-11shows each Misc (Miscellaneous) configuration option as it appears on the LCD.

Table 3-11

(1 of 2)

Miscellaneous Configuration Options

StrapsWhenDisc: No_Change

Nxt No_Change Reload RelodNoATChg

Straps When Disconnected. Determines whether or not configuration options in the Active (Saved) configuration area are reloaded to Active (Operating) when a disconnect occurs. This is useful in modem pooling applications.

No Change ± Configuration options do not change upon disconnect.

Reload ± The Active (Operating) configuration area, which controls modem operation, is reloaded from the Active (Saved) configuration area when a disconnect occurs. This is useful in modem pooling applications where it is desirable to start the modem from a known condition after every call. This allows multiple users to issue AT commands to change the modem's operation for their particular call.

Reload, No AT Change ± This has the same effect as Reload, except that it becomes impossible to change this configuration option with an AT command, and the command buffer is cleared so that /A (Repeat Last Command) has no effect.

NOTE: If Reload or RelodNoATChg is selected, the following AT commands are disabled although the OK result code appears when these commands are issued:

AT&Fn. Loads a factory default template into Active(Operating)

AT&Wn. Writes Active(Operating) to Active(Saved) or Customer 1 or Customer 2.

AT&Zn=x. Store directory numbers

Factory default templates do not affect the setting of StrapsWhenDisc.

AT command equivalent is S88=n.

Access frm Remt: Enable

Nxt Enable Disable

Access from Remote. Determines if your modem's SDCP can be accessed by a remote modem via the VF line.

If this configuration option is disabled, the modem cannot be accessed by another modem, and the Clone to Remote feature is not available.

Enable ± Allows access from a remote modem.

Disable ± Does not allow access from a remote modem.

The factory default templates do not affect Access from Remote.

NOTE: The remote modem must be a 3800Plus modem.

AT command equivalent is S-register S55=n.

RemAccssPasswrd: 00000000

Nxt ￿ 00000000

Remote Access Password. Allows the entry of a password for establishing control of a remote modem from the SDCP of a local modem. The same password must be used in both the local and remote modem.

NOTE: If the Access from Remote configuration option is set to Disable, the password has no effect.

AT command equivalent is the combination of S-registers S56=n, S57=n, S58=n, and S59=n.

3821-A2-GB20-40 January 1999 3-45