Paradyne SNMP DSU, 7610 manual Synchronous Port Table Objects, Rs232Async, Rs232Sync

MIB Descriptions

Table C-9. Asynchronous Port Table Objects (2 of 2)

Object	Description	Setting/Contents
rs232AsyncPort	Specifies the type of parity	Supports only the following values:
Parity	used by the port.	none(1) ± No parity bit
(rs232Async
PortEntry 4)		odd(2) ± Odd parity
		even(3) ± Even parity
rs232AsyncPort	Specifies the ability to	Supports only the following values:
AutoBaud	automatically sense the	disabled(2) ± Does not support
(rs232Async	input speed of the port.
		Autobaud.
PortEntry 5)

Synchronous Port Table Objects

The Synchronous Port Table Objects contains an entry for the synchronous user data port and the Management port when this port is configured for synchronous operation. For this unit, entries in the table that are counters (rs232SyncPortEntry 3±7) are used to collect statistics only and are not supported. Clarification for objects contained in this table as it applies to the unit is provided below.

Table C-10. Synchronous Port Table Objects (1 of 2)

Object	Description	Setting/Contents
rs232SyncPort	Specifies the clock source	Supports only the following values:
ClockSource	for the port.	internal(1) ± The port uses an internal
(rs232Sync
		clock.
PortEntry 2)
		split(3) ± The port uses an external
		transmit clock and internal receive clock.
rs232SyncPort	Specifies whether this	Supports only the following value:
Role	device interface is a DTE or	dce(2) ± The port acts as a DCE.
(rs232Sync	DCE.
PortEntry 8)
rs232SyncPort	Specifies the bit encoding	Supports only the following value:
Encoding	technique that this port	nrz(1) ± The port uses non-return to
(rs232Sync	uses.
		zero encoding.
PortEntry 9)
rs232SyncPort	Specifies the method used	Supports only the following values:
RTSControl	to control the RTS signal.	controlled(1) ± For User Data port, this
(rs232Sync	Refer to Data Port Options,
		value is used when the Data Port option
PortEntry 10)	Table A-3.
		Carrier Control by RTS is set to
		Switched.
		constant(2) ± For User Data port, this
		value is used when the Data Port option
		Carrier Control by RTS is set to
		Constant. This is the only valid value for
		the Management port.

7610-A2-GB20-10 November 1997 C-15