Paradyne SNMP DSU, 7610 manual Ppp

MIB Descriptions

Table C-2. Interfaces Group Objects (2 of 4)

Object	Description	Setting/Contents
ifType	Identifies the interface	Supported values:
(ifEntry 3)	type based on the	H other( 1 ) ± Used for the DDS network.
	physical/link
	protocol(s), right below	H ppp( 23 ) ± Used for the In-band
	the network layer.	Management Channel and for the
		Management port, when configured for
		PPP.
		H slip( 28 ) ± Used for Management port,
		when configured for SLIP.
		H rs232( 33 ) ± Used for the Terminal port
		and the Management port, when not
		configured as Net Link.
		H v35( 45 ) ± Used for the User Data port.
ifMtu	Identifies the largest	Number of octets.
(ifEntry 4)	datagram that can be
	sent or received on an
	interface (Management
	port or IMC).
ifSpeed	Provides the current	H Management port ± Configured data rate
(ifEntry 5)	bandwidth for the	for the port.
	interface in bits per	H Terminal port ± Configured data rate for
	second.
		the port.
		H DDS ± Line rate of 56,000 or 64,000 bps,
		reflecting the line rate detected by the unit.
		H User data (DTE) port ± Current data rate of
		the port (DDS operating rate minus IMC
		rate).
		H In-band Management Channel ±
		Configured data rate for the In-band
		Management Channel.
ifAdminStatus	Provides interface	H up(1) ± The interface is enabled.
(ifEntry 7)	status. Supported as	H down(2) ± The interface is disabled.
	read-only.

7610-A2-GB20-10 November 1997 C-5