Paradyne SNMP DSU, 7610 manual User Interface Options Menu, Terminal Port Options

Configuration Option Tables

Table A-3. Data Port Options (3 of 3)

Monitor DTR

Possible Settings: Enable, Disable

Default Setting: Enable

Indicates to the DSU whether to monitor the Interchange Circuit CT108, Data Terminal

Ready (DTR), from the DTE.

Enable ± The DSU monitors the state of DTR on the User Data (DTE) port. Based on the Link Traps option setting in Table A-12, the DSU uses the DTR circuit to trigger a Link Up/Down SNMP trap and a Health and Status message.

Disable ± DTR is not monitored by the DSU. Use when a DTE does not provide the

DTR lead at the interface.

User Interface Options Menu

The User Interface Options Menu includes the following:

HTerminal Port Options, Table A-4

HManagement Port Options, Table A-5

HExternal Device Options, Table A-6

HTelnet Session Options, Table A-7

Terminal Port Options

To access the Terminal Port Options screen, follow this menu selection sequence:

Main Menu → Configuration → Load Configuration From → Edit →

User Interface → Terminal Port

Table A-4. Terminal Port Options (1 of 3)

Data Rate (Kbps)

Possible Settings: 2.4, 4.8, 9.6, 14.4, 19.2, 28.8, 38.4

Default Setting: 9.6

Data rate in kbps on the Terminal port.

2.4to 38.4 ± Selects a Terminal port data rate from 2.4 to 38.4 kbps.

Character Length

Possible Settings: 7, 8

Default Setting: 8

Specifies the number of bits needed to represent one character, including the parity bit. 7 or 8 ± Sets the bits per character.

7610-A2-GB20-10 November 1997 A-11