Security

Creating a Login

Logins apply to Terminal port and Telnet access to the ATI. Six login ID/password combinations are available. Each Login ID and Password must be unique and include an access level.

For additional information regarding the ATI access using the Login Required option, refer to the ATI Access section.

"Procedure

1.To create a login record, follow this menu selection sequence: Main Menu Control Administer Logins

2.Press Ctrl-a to switch to the screen function key area below the dotted line.

3.Select New and press Return.

4.Create the login by entering the following fields. For valid entries in the first two fields, refer to the ASCII Characters section of Appendix A.

On the Administer

Enter . . .

Logins screen, for the . . .

 

 

Login ID

1 to 10 ASCII printable characters

 

 

Password

1 to 10 ASCII printable characters

 

 

Access Level

Level 1, Level 2, or Level 3

 

 

NOTE:

Assign at least one Level 1 Access Level. Full access is necessary to make configuration option changes and administer logins. If there is no effective access level 1, refer to the Device Reset section of Chapter 7.

5.Press Ctrl-a to switch to the screen function key area below the dotted line. Select Save and press Return.

6.When Save is complete, Command Complete appears at the bottom of the screen. The cursor is repositioned at the Login ID field, ready for another entry.

4-2

November 1997

7610-A2-GB20-10

Page 29
Image 29
Paradyne 7610, SNMP DSU manual Creating a Login, On the Administer Enter Logins screen, for