Testing

Tests Available

From the Test menu, you can run network tests, data port tests, and a lamp test for the front panel LEDs. Loopbacks can be initiated locally and remotely. Refer to Loopbacks, Table 7-2.

The Test menu is limited to users with an access level of 1 or 2. To access the

Test menu, follow this menu selection sequence:

Main Menu Test

Network tests require the participation of your network service provider.

The DSU supports physical-level tests independently on a per-interface basis.

HThe CSU and DSU loopbacks and 511 test pattern send/monitor are supported on the network interface.

HThe Local Loopback and 511 test pattern send/monitor are supported on the DTE port.

Network Tests

To access the Network Tests screen, follow this menu selection sequence:

Main Menu Test Network Tests

main/test/network

 

 

 

 

 

Device Name:

 

 

 

Model: 7610

 

 

 

NETWORK TESTS

 

 

 

 

Test

Command

Status

Result

 

 

 

CSU Loopback:

Start

Inactive

0:00:00

 

 

 

DSU Loopback:

Start

Inactive

0:00:00

 

 

 

Send V.54 Up:

Send

Sending

 

 

 

 

Send V.54 Down:

Send

Inactive

 

 

 

 

Send 511:

Start

Inactive

0:00:00

 

 

 

Monitor 511:

Stop

Active

125:08:48

Errors 99999+

±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±È±±±±±±±±±±±±±±±±±±±±±±±±±±±±±

Ctrl-a to access these functions, ESC for previous menu MainMenu Exit ResetMon

Use the Command column to start or stop a test by pressing Enter. The Result column displays the test duration since the last device reset. When the Monitor 511 test is active, ResetMon is available to reset the error counter to zero.

Selecting the Stop command on the Network Test screen or Abort All Tests from the Test menu will not disrupt a network-initiated loopback.

7-2

November 1997

7610-A2-GB20-10

Page 47
Image 47
Paradyne 7610, SNMP DSU manual Tests Available, Network Tests