Polycom 40/0 manual Configure Port Settings, Set the System Time, To configure the port

System Configuration

Outbound Proxy Server

For communication with the SIP server when the system is configured on the internal network, an outbound proxy server is required to implement traversal of the firewall or NAT. In this case, you need to set the IP address and port number for the outbound proxy server.

•Server Address: Enter an address of the SIP server.

•Server Port: Enter the port of the SIP server.

3Click OK.

•If you need to configure both H.323 Gatekeeper parameters and SIP parameters at the same time, click OK after you finish the configuration of both parameters.

•If the RealPresence Capture Server is registered to DMA as SIP server, you can find Capture Server's information on DMA portal under Network > Endpoints.

Configure Port Settings

Port Settings allow specific ports in the firewall network environment to be allocated to multimedia calls.

To configure the port:

1Go to Configuration > Port Settings.

2Select Enable port configuration.

3Configure the following settings:

Port Parameters

Parameter	Description
TCP Ports	Specify the TCP port range.
	You can set the starting port number (the default value is 10000), and the
	ending port number is calculated automatically.
UDP Ports	Specify the UDP port range. You can set the starting port number (the default
	value is 20000), and the ending port number is calculated automatically.
Streaming Port	Specify the streaming port range. The default value is 1640.
Multicast Port	Specify the multicast port range. The default value is 1641.

4Click OK. The recording server restarts to apply your changes.

Set the System Time

You also can set the RealPresence Capture Server system time from the Admin Portal.

To set the system time:

1 Go to Configuration > System Time.

Polycom, Inc. 30