Polycom 40/0 manual To configure the SIP settings, Go to Configuration Signaling Settings SIP

System Configuration

System H.323 Alias	Specify the H.323 alias for the system.
Remote Display Name	Specify the name to be displayed to the far end.
	Note: If you set the remote display name with dual-bytes characters like
	Chinese, you will not see the characters on the far end endpoints in a
	H.323 call between endpoints and the Capture Server system.

If the RealPresence Capture Server is registered to DMA as gatekeeper, you can find Capture Server's information on DMA portal under Network > MCU > MCUs.

SIP

If your network supports SIP, you can use SIP to connect video calls. RealPresence Capture Server supports SIP integration with SIP servers such as the Polycom DMA.

To configure the SIP settings:

1Go to Configuration > Signaling Settings > SIP.

2Configure the following settings:

SIP Parameters

Parameter	Description
Transport Type	Specify the transport layer protocol used for communicating with the SIP
	server. It needs to be consistent with the protocol supported by the SIP
	server.
Enable Certificate Validation	Specify whether to validate the server’s certificate before accepting it.
	This option is available only after you select TLS as the Transport Type.
	Note: RealPresence Capture Server always sends its own certificate to the
	server, regardless of the selection here.
Register to SIP Server	Specify whether to register the system to the SIP server.
SIP Server Type	Choose a SIP server type from the dropdown list, currently only Generic
	available.
SIP Server status	Specify:
	•	Server Address
	•	Server Port
	•	Server Domain Name
	Note: Never enter Capture Server IP for Server Address.
Register User’s Information	Specify:
	•	User Name
	•	Auth User Name
	•	User Auth Password

Polycom, Inc. 29