FastTrak100 User Manual
Installing Drivers with Existing Windows 95/98
The following three sections detail the installation of FastTrak100 drivers on a system that has Windows 95/98 already installed. If you’re installing the FastTrak100 drivers on a system during a Windows 95/98 installation, see “Installing Drivers During Windows 95/98 Installation” on page 38.
Windows 98
1.After installing the FastTrak100 controller card and configuring the hard drives, power up the system and boot Windows.
2.The “Add New Hardware Wizard” will appear, informing you that it has found a “PCI RAID Controller.”
3.Check the “Search for the best driver for your device” box and click the Next button.
4.Check the “Specify a Location” box and click Next button.
5.Type
6.Insert the “FastTrak100 Driver” diskette in drive A:.
7.Click on “Next.” The Add New Hardware wizard will say it has found “Win95- 98 Promise FastTrak100 (tm) controller”.
8.Click on “Next,” and then on “Finish.”
9.Choose “Yes” when asked if you want to restart your computer. Be sure to eject the diskette from drive A:.
Windows 95
1.After installing the Ultra100 controller card and configuring the hard drives, power up the system and boot Windows.
2.The “Update Device Drive Wizard” will appear, informing you that it has found a “PCI Mass Storage Controller.”
3.Insert the “FastTrak100 Driver” diskette in drive A:.
4.Type
5.Click on “Finish,” and when prompted to insert the “FastTrak100 Driver” diskette, click on “OK.”
6.If a message informing you that the file “FastTrak100.MPD” cannot be found, go to the “Copy files from:” text box and type:
7.Choose “Yes” when asked whether you want to start your computer. Be sure to remove the diskette from drive A
40
