Go To Standby
Purpose: The purpose of this command is to place the Serial Adapter in Standby mode in order to conserve current. For this command to work properly, the RTS line at the Serial Adapters serial connector must be inactive. The Serial Adapter can be removed from Standby mode by asserting the RTS line.
Response Expected from Serial Adapter = None.
Message format:
BYTE | command (ASCII ‘G’, 47H) |
Initialize Serial Adapter
Purpose: To initialize the Serial Adapter.
Response Expected from Serial Adapter: “Initialization Confirma- tion”
Message Format: |
|
BYTE | command (ASCII ‘I’, 49H) |
BYTE | seqno |
Set Radio Channel
Purpose : To set the Serial Adapter’s radio channel.
Response Expected from Serial Adapter: “Radio Channel Confir- mation”
77
