Applying various effects to the sound
■Adjusting the sensitivity of the D Beam controllers
(D BEAM SENS)
The sensitivity of the D Beam controller will change depending on the amount of light in the vicinity of the unit. If it does not function as you expect, adjust the sensitivity as appropriate for the brightness of your location. Increasing this value will raise the sensitivity.
1.Press [SOLO SYNTH], [ACTIVE EXPRESS], or [ASSIGNABLE] so it is lit.
2.Press [PARAM].
3.Use PAGE/CURSOR [ 
]/[ 
] to select “Sens.”
fig.q05-16_40
4.Use VALUE [-]/[+] to adjust the sensitivity.
Value: 1–10
As you increase this value, the D Beam controller will become more sensitive. Normally, you will leave it at a setting of “5.”
5.Press [EXIT] or [PARAM] to return to the previous screen.
■Changing the polarity of the change
(D BEAM POLARITY)
By changing the D Beam Polarity setting, you can invert the direction of the effect that is applied.
1.Press [SOLO SYNTH], [ACTIVE EXPRESS], or [ASSIGNABLE] so it is lit.
2.Press [PARAM].
3.Use PAGE/CURSOR [ 
]/[ 
] to select “Polarity.”
fig.q05-17_40
4.Use VALUE
Value: NORMAL, REVERSE
5.Press [EXIT] or [PARAM] to return to the previous screen.
This setting remains stored in memory even while the power is off.
This setting remains stored in memory even while the power is off.
34
