Schneider Electric 890USE17700 manual Configuration, p error

The STB NIP 2212 NIM

RUN	ERR (red)	TEST	Meaning
(green)		(yellow)
off	blink: 2	off	Configuration mismatch detected after power up—at
			least one mandatory module does not match; the island
			bus is not started.
off	blink: 2	off	Assignment error—the NIM has detected a module
			assignment error; the island bus is not started.
	blink: 5		Internal triggering protocol error.
off	blinking	off	Fatal error—Because of the severity of the error, no
	(steady)		further communications with the island bus are
			possible and the NIM stops the island. The following
			are fatal errors:
			significant internal error
			module ID error
			auto-addressing (See Auto-Addressing, p. 46)
			failure
			mandatory module (See Configuring Mandatory
			Modules, p. 153) configuration error
			process image error
			auto-configuration/configuration (See Auto-
			Configuration, p. 49) error
			￿island bus management error
			receive/transmit queue software overrun error
on	off	off	The island bus is operational.
on	blink 3	off	At least one standard module does not match—the
			island bus is operational with a configuration mismatch.
on	blink: 2	off	Serious configuration mismatch (when a module is
			pulled from a running island)—the island bus is now in
			pre-operational mode because of one or more
			mismatched mandatory modules.
blink: 4	off	off	The island bus is stopped (when a module is pulled
			from a running island)—no further communications
			with the island are possible.
off	on	off	Fatal error—internal failure.
[any]	[any]	on	Test mode is enabled—the configuration software or
			an HMI panel can set outputs. (See 2.)

1 The TEST LED is on temporarily during the Flash overwrite process.

2 The TEST LED is on steadily while the device connected to the CFG port is in control.

32 890USE17700 April 2004