Schneider Electric 890USE17700 manual STB NIP 2212 Network Interface, NIM toward the top

The STB NIP 2212 NIM

STB NIP 2212 Network Interface

Introduction	The fieldbus interface on the STB NIP 2212 is the point of connection between an
	Advantys STB island and the Ethernet LAN on which the island resides. This
	fieldbus interface is also called the Ethernet port.
	The fieldbus interface is a 10Base-T port with an RJ-45 female connector. Category
	5 (CAT5) twisted pair electrical wiring, either shielded or unshielded (STP/UTP), is
	used to connect the STB NIP 2212 to the Ethernet baseband.
	Note: Because the Ethernet port is configured for Modbus over TCP/IP services (SAP 502),
	the Advantys configuration software can run over the fieldbus interface on the STB NIP 2212.
Fieldbus	The interface for 10Base-T connections is located on the front of the STB NIP 2212
(Ethernet) Port	NIM toward the top:

8 1 eight-pin connector

The RJ-45 connector is an eight-pin female connector. The eight pins connect horizontally along the top. Pin 8 has the leftmost position, and pin 1 is the rightmost. The pin-out for the RJ-45 complies with the information in the following table:

Pin

1

2

3

4

5

6

7

8

Description

tx+

tx-

rx+

reserved

reserved

rx-

reserved

reserved

26 890USE17700 April 2004