Schneider Electric 890USE17700 manual Configuration Password Protection, Logging In and Out

STB NIP 2212 Web Server

Configuration Password Protection

Introduction

Set

Configuration

Password

Procedure

The configuration password controls read/write access from the STB NIP 2212 web site to the physical module’s Flash memory. This password must be set up on the Change Configuration Password web page.

Use the following procedure to set up a configuration password for your STB NIP 2212 web site:

Step	Action	Result
1	Click on the Security tab.	The Security menu is
		displayed.
2	Click on the Change Configuration Password	The Change Configuration
	option.	Password page is displayed.
3	In the New Password field, type your configuration
	password.
	The password must have six alphanumeric
	characters. The characters are case-sensitive.
4	Type the password again in the Confirm New
	Password field.
5	Click on the Save button.	The configuration password
		takes effect immediately.

Logging In and Out

If you set up a configuration password, the following login procedure takes effect:

Step	Action	Result
1	Type the configuration password for your	The Login button toggles to Logout.
	web site next to the Logout button (See	Your entire STB NIP 2212 web
	Sample Login Prompt, p. 90).	session is now write enabled.
	Note: The password is case-sensitive.
2	Perform the write operation, e.g., configure
	a role name from the Role Name web page
	(See Configuring a Role Name, p. 82).
3	Click on the Logout button to end write	The Logout button toggles to Login.
	privileges on your web site.	Write protection for your web site is
		restored.

890USE17700 April 2004 89