Schneider Electric 890USE17700 manual Valid IP Address, Settings

		The STB NIP 2212 NIM
Summary of	Each rotary switch position that you can use to set a valid IP address is marked on
Valid IP Address	the STB NIP 2212 housing (See Physical Description, p. 28). The following
Settings	information￿	summarizes the valid address settings:
	For a switch-set role name, select a numeric value from 00 to 159. You can use
	both switches:
	￿On the upper switch (tens digit), the available settings are 0 to 15.
	On the lower switch (ones digit), the available settings are 0 to 9.
	The numeric setting is appended to the STB NIP 2212 part number, e.g.,
	STBNIP2212_123, and a DHCP server assigns it an IP address.
	For a BootP-served IP address (See Server-AssignedIP Addresses, p. 62),
	￿select either of the two BOOTP positions on the bottom switch.
	If you set the bottom switch to either of the two INTERNAL positions, the
	IP address will be assigned by one of the following methods:
	if the STB NIP 2212 is direct from the factory, it has no software set
	IP parameters and will use a MAC-based IP address (See Deriving an
	IP Address from a Media Access Control (MAC) Address, p. 61).
	a fixed IP address using the STB NIP 2212 web configuration pages (See
	￿Web-Based Configuration Options, p. 71)
	a web-configured role name (See Configuring a Role Name, p. 82) in
	association with a DHCP server
	Note: For information about how the STB NIP 2212 prioritizes IP addressing
	options, refer to the IP parameterization flow chart (See Determining the
	IP Address, p. 63).
	Note: The STB NIP 2212 requires a valid IP address to communicate on the
	Ethernet network and with a host. You must power cycle the STB NIP 2212 to
	configure the STB NIP 2212 with an IP address set with these rotary switches.

890USE17700 April 2004 29