Schneider Electric 890USE17700 Ethernet Communications LEDs, Advantys STB Communications LEDs

The STB NIP 2212 NIM

Ethernet

Communications

LEDs

The 10T ACT and the STATUS indicate the conditions described in the following table:

Label	Pattern	Meaning
10T ACT (green)	on	The network is alive and healthy.
	off	The network is not alive and not healthy.
	steady on	The Ethernet LAN is operational.
	steady off	No MAC address found.
	blinking	Initializing the Ethernet network.
	blink: 3	No link pulse detected.
LAN ST (green)	blink: 4	Duplicate IP address detected.
	blink: 5	Obtaining IP address (See The IP Address
		Assignment Process, p. 63).
	blink: 6	Using the default IP address (See Deriving an
		IP Address from a Media Access Control (MAC)
		Address, p. 61).

Advantys STB

Communications

LEDs

The table that follows describes the island bus condition(s) communicated by the LEDs, and the colors and blink patterns used to indicate each condition.

RUN	ERR (red)	TEST	Meaning
(green)		(yellow)
blink: 2	blink: 2	blink: 2	The island is powering up (self test in progress).
off	off	off	The island is initializing—it is not started.
blink: 1	off	off	The island has been put in the pre-operational state by
			the RST button—it is not started.
		blink: 3	The NIM is reading the contents of the removable
			memory card (See Using the STB XMP 4440 Optional
			Removable Memory Card to Configure the Island Bus,
			p. 53).
		on	The NIM is overwriting its Flash memory with the card’s
			configuration data. (See 1.)
off	blink: 8	off	The contents of the removable memory card is invalid.
blinking	off	off	The NIM is configuring (See Configuring the Island
(steady)			Bus, p. 45) or auto-configuring (See Auto-
			Configuration, p. 49) the island bus—the bus is not
			started.
blinking	off	on	Auto-configuration data is being written to Flash
			memory. (See 1.)
off	blink: 6	off	The NIM detects no I/O modules on the island bus.

890USE17700 April 2004 31