Schneider Electric 890USE17700 manual IP Parameters Using the Command Buttons

STB NIP 2212 Web Server

IP Parameters

Using the

Command

Buttons

The IP address for the STB NIP 2212 has the four parameters, which are described in the following table:

Parameter	Description
IP address	Unique 32-bit address assigned to every node on the Internet.
subnet mask	The subnet mask is 32 bits assigned with the IP address of a host. The
	contiguous 1’s of the mask are used to separate the network portion from the
	host portion of the address. When the subnet mask is applied to the source
	and destination addresses, it determines if the target host is on the local
	subnet or on a remote network.
gateway	The default gateway, typically a router, is where the host sends frames that
	are bound for remote networks after the subnet mask compare.
frame type	Data format used by a protocol. For example, the STB NIP 2212 can use
	either the Ethernet II or the IEEE 802.3 frame format. Ethernet II is the default.

Note: The IP address for the STB NIP 2212 is written in dotted decimal format.

The following table describes how to use the command buttons on the Configured IP web page:

To ...	Click on ...
Display the IP address stored in Flash memory	Reset
Display the MAC-based, derived default IP address.	Default
Save the IP address displayed on the Configured IP web page.	Save
Configure the STB NIP 2212 with the IP address displayed on the	Reboot
Configured IP web page.

890USE17700 April 2004 73