LOADING PAPER
The bypass tray can be used to print on plain paper, postcards, label sheets, tabbed paper, and other special papers. When using SHARP standard paper, up to 100 sheets can be loaded (up to 20 postcards) for continuous printing similar to the other trays. For the paper types that can be used in the bypass tray, see "Specifications of paper trays (Types and sizes of paper that can be used in the trays)" on page
NOTE
After loading the paper in the bypass tray, be sure to set the paper type and size (step 4) if these were changed.
1 Open the bypass tray.
When loading 11" x 17",
or
A4R size paper, be sure
to pull the auxiliary tray all the way out. If the auxiliary tray is not
pulled all the way out, the size of the loaded paper will not be correctly displayed.
4 Set the type and size of the paper loaded in the bypass tray.
If the paper size was changed from an inch size to an AB size, or from an AB size to an inch size, or if the paper type was changed, be sure to change the appropriate settings as explained in "Setting the paper type and paper size" (see page
5 This completes the procedure for loading paper in the bypass tray.
■Loading tabbed paper in the bypasstray[Example]
Make sure that the positions of the tabs correspond with the originals as shown below.
2 Set the bypass tray guides to the width of the copy paper.
3 Insert the copy paper all the way into the bypass tray. (Do not force the paper in.)
Original
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ABC |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
| DEF |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
| GHI |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| JKL |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1st page |
| 2nd page 3rd page 4th page | ||||||||||||
Place the tabbed paper face up.
Tabbed paper
Front side
1st page 
2nd page
3rd page 4th page
Place the copy paper face up. If the bypass tray guides are set wider
than the copy paper, the
inside of the machine
may become soiled, resulting in smudges on succeeding copies. A gap may cause skewing
or wrinkling.
Front