
FINISHER AND SADDLE STITCH FINISHER
1 Perform steps 1 to 3 of the procedure for "Replacing the cartridge in the saddle stitch finisher" on page
2 Remove the empty staple case.
3 While pushing down on lever (A), pull up knob (B) .
(A)
(B)
4 Remove any jammed staples, and then return knob (B) to its original position.
(B) | Be sure to remove any |
| strips of staples. |
Jammed staples
5 Return the staple case to its original position.
6 Return the saddle stitch holder and the saddle stitch unit to their respective original positions.
7 Make sure that the finisher is firmly attached to the machine and that 11" x 17",
If one of the above paper sizes is not set, test stapling cannot be performed.
8 Close the lower cover of the finisher.
Test stapling is automatically performed on a blank sheet.
This operation is carried out to avoid blank stapling.
NOTE
If test stapling fails to take place, repeat steps 1 to 7.
NOTE
Do not touch the stapling area.
The stapler could injure you.
■Disposal of hole punch scrap (when the punch module is installed)1 Open the cover of the hole punch module.
2 Holding the black handle, slide out the case containing the paper bits, and dispose of them properly.
3 Return the waste case to its original position.
4 Close the cover of the hole punch module.