Sharp feeder, ■ Using the document glass, ■ Using the automatic document

PLACING ORIGINALS

■ Using the automatic document	■ Using the document glass
feeder

1 Open the document cover, make sure that an original has not been left on the document glass, and then gently close the document cover.

2 Adjust the original guides to the size of the originals.

3 Place the originals face up in the document feeder tray.

Place the originals face up.

Open the document cover, place the original face down on the document glass, and then gently close the document cover.

NOTE

Do not place any objects under the original size detector, because they may damage it or the original size may not be detected properly.

4

Document glass scale	Document glass scale
mark	mark

		8½x11
	8½x14	or A4
	or B4
8½x11 or A4	11x17 or A3

Insert the originals all

the way into the document feeder. The stack height must not be higher than the indicator

line (maximum of 150 pages).

●Align the corner of the original with the tip of the

arrow mark on the document glass scale.

●Place the original in the appropriate position for its size as shown above.

NOTE

Original size detection function

One of the four groups of standard original sizes shown below can be selected for detection by the original size detection function. The factory default setting is "INCH-1". The setting can be changed using "ORIGINAL SIZE DETECTOR SETTING" in the key operator programs.

		Detectable original sizes
	Group	Document feeder tray (for reversing automatic document feeding)
		Document glass
1	INCH-1	11" x 17", 8-1/2" x 14", 8-1/2" x 11",	Document glass + A4
		8-1/2" x 11"R, 5-1/2" x 8-1/2"
2	INCH-2	11" x 17", 8-1/2" x 13", 8-1/2" x 11",	Document glass + A4
		8-1/2" x 11"R, 5-1/2" x 8-1/2"
3	AB-1	A3, A4, A4R, A5,B4, B5, B5R	Document glass + 8-1/2" x 11", 216x330
4	AB-2	A3, A4, A4R, A5,B5, B5R, 216x330	Document glass + 8-1/2" x 11", B4

4-3