FINISHER AND SADDLE STITCH FINISHER

Removing a misfeed

When a misfeed occurs, remove the misfed paper as explained below.

■General procedure for the finisher and saddle stitch finisher

1 Gently move the finisher/saddle stitch finisher away from the machine while pressing the button.

When an inserter is installed, separate the

inserter from the machine while pressing on the inserter button.

6 Remove any misfed paper from the paper exit area.

Be careful not to tear the misfed paper during removal.

2 Removeunit. the misfed paper from the main

After removing the misfed paper, perform steps 1 and 3 on page 2- 19 to reset the machine.

3 Open the upper cover of the finisher/ saddle stitch finisher.

When an inserter is

(A) installed, lift the tray of the inserter.

4 Lift knob (A) (See the step 3 figure), then remove any misfed paper.

Be careful not to tear the misfed paper during removal.

7 Close the upper cover of the finisher/

3

saddle stitch finisher.

 

■When a saddle stitch finisher is installed

8 Open the front cover of the inserter (only when an inserter is installed).

9 Open the lower cover of the saddle stitch finisher.

(B)

5 Lift knob (B) (see the illustration in step 4) and remove any misfed paper.

Be careful not to tear the misfed paper during removal.

10Open the entrance cover of the saddle stitch unit.

3-11