Sharp MX-3501N, MX-4501N, MX-2700N, MX-2300G, MX-2300N, MX-2700G, MX-3500N, MX-4500N manual Output

OUTPUT

To select output functions and the output tray, touch the [Output] key in the base screen of copy mode. Output functions that can be selected are sort, group, offset, staple sort, saddle stitch, and punch. All settings are explained in this section based on the assumption that a saddle stitch finisher, punch module and right tray are installed.

(1)	(2)	(3)	(4)	(5)	(6)	(7)
			Output	Offset	Right Tray	OK
				Tray
			Sort
			Staple		Saddle
			Sort
					Stitch	Punch
			Group	Offset

(8) (9) (10)

(1)[Group] key

This is used to group copies by page.

☞Group mode (page 43)

(2)[Staple Sort] key

This is used to sort the output into sets, staple each set, and deliver the sets to the tray. (Note that the sets will not be offset in the output tray.) When this function is selected, three keys will appear for selecting the staple position.

☞Staple sort function / Saddle stitch function (page 44)

(3)[Sort] key

This is used to sort (collate) output into sets.

☞Sort mode (page 43)

(4)Output display

An icon will appear to indicate the output mode.

(5)[Offset Tray] key ([Centre Tray] key*)

This is used to offset each set of output from the previous set in the offset tray (centre tray). The [Offset Tray] key is automatically selected when the [Staple Sort] key is selected.

*When only a right tray is installed, this appears as the "Centre tray".

(6)[Right Tray] key

Select this key to have output delivered to the right tray. When the right tray is selected, offset, staple sort, saddle stitch, and punch cannot be selected.

(7)[OK] key

Touch this key to close the output screen and return to the base screen.

(8)[Offset] key

This is used to offset each set of output from the previous set.

The offset function operates when the checkbox is

selected and does not operate when the checkbox is

not selected . (The offset checkmark is automatically cleared when the staple sort function is selected.)

☞Offset function (page 43)

(9)[Saddle Stitch] key

This is used to staple and fold each set of copies at the centreline.

☞Staple sort function / Saddle stitch function (page 44) When this key is touched, the saddle stitch setting screen appears. (Only when "Automatic Saddle Stitch" is enabled in the system settings (administrator).)

(10)[Punch] key

This is used to punch holes in the output.

☞Punch function (page 45)

The keys that appear and that can be selected will vary depending on what peripheral devices are installed.

Depending on what peripheral devices are installed, it may not be possible to select certain keys. If your screen is different from the above screen, see the screens below.

Display example 1	Display example 2	Display example 3
The screen when a right tray, finisher, and	The screen when a right tray is installed. The screen when a right tray, finisher
saddle stitch finisher are not installed.		and punch module are installed.

Output	OK	Output	Centre		OK	Output	Offset	OK
				Right Tray				Right Tray
			Tray				Tray
Sort		Sort				Sort
						Staple
						Sort		Punch
Group		Group	Offset			Group	Offset
Offset

42