Siemens 9016, 9014, 9015 E manual Size SC 3

Select barcode				Barcodes
p	Specification of bar height; bar height = p x 1	/	1 2	inch. A decimal whole number with
3	3

one or two digits (from 1 to 99) can be specified.

EAN and UPC codes with add-on code (EAN Add-On 2 or EAN Add-On 5)

!require a minimum height of 3 /12 inch.

Value of	p4		p5		p6
decimal	Width of bar		Width of space		Ratio of
place					wide to
	Code direction		Code direction		narrow
	horizontal	vertical	horizontal	vertical
0	0.35 mm	0.28 mm	0.35 mm	0.28 mm	2.0 to 1
1	0.53 mm	0.42 mm	0.53 mm	0.42 mm	2.5 to 1
2	0.70 mm	0.56 mm	0.70 mm	0.56 mm	3.0 to 1
3	0.88 mm	0.70 mm	0.88 mm	0.70 mm	3.5 to 1
4	1.05 mm	0.85 mm	1.05 mm	0.85 mm	---
5	1.23 mm	0.99 mm	1.23 mm	0.99 mm	---
6	1.41 mm	1.12 mm	1.41 mm	1.12 mm	---
7	1.58 mm	1.27 mm	1.58 mm	1.27 mm	---

These values change with the degree of saturation of the ribbon. They are thus only valid for a new ribbon.

The module width is standardized with the EAN and UPC codes. The following values are valid for p6 when setting the barcode:

p6		= 0	Size: SC 3 1)
p	6	= 1	Size: SC 6 1)
p		= 2	Size: SC 9 1)
	6
p		= 3	Size: SC 3 1)
	6

1)SC 3, SC 6 and SC 9 refer to the DIN standard.

The ratio of wide to narrow is fixed with Code 93, MSI Mod 10/10 and Code 128. p6 is thus not required and is ignored. POSTNET does not require the parameters p4, p5 and p6.

Programmer Reference Guide U26169-J-Z716-1-7600