Forms layout | IBM Proprinter emulation |
Forms layout
The dimensions of the form can be selected freely. The following commands are available:
●Set form length in lines
●Set form length in inches
●Set perforation skip mode
●Reset perforation skip mode
●Set first print line
●Set left margin
●Set left and right margins
Set form length in lines
Control sequence | Hexadecimal | Decimal |
|
|
|
ESC C p1 | 1B 43 p1 | 27 67 p1 |
This command specifies the physical page length in multiples of the current line spacing and sets the current vertical position as the first print line (top of form).
The set page length is not affected by later changes of the line spacing.
p1 | Form length in multiples of the current line spacing | |
| Range: | X’01 ≤ p1 ≤ X’7F |
|
| The minimum valid form length is 3 inches and the |
maximum is 22 inches.
Programmer Reference Guide |
