Forms layoutEpson LQ-2550 emulation
Set form length in inches
Control sequence |
| Hexadecimal | Decimal | |
|
|
|
| |
ESC C NUL p1 |
| 1B 43 00 p1 | 27 67 00 p1 | |
This command specifies the physical form length in inches and sets the current vertical | ||||
position as the first print line (top of form). |
| |||
p1 | Form length in inches |
|
| |
| Range: | X’01 ≤ p1 ≤ X’16 |
| |
|
|
| The minimum form length is 3 inches and the | |
|
|
| maximum form length is 22 inches. |
Set perforation skip mode
Control sequence | Hexadecimal | Decimal |
|
|
|
ESC N p1 | 1B 4E p1 | 27 78 p1 |
The perforation area is specified in number of lines at the current line spacing.
The perforation area is not changed by later changes of the line spacing. It is skipped at the end of every page.
The perforation area must be selected so that at least 4 /6 inch remain as print area.
The perforation skip mode is reset by changing the form length or by the Reset perforation skip mode command.
p1 | Perforation area in lines at the current line spacing | |
| Range: | X’01 ≤ p1 ≤ X’7F |
Programmer Reference Guide |