>set brightness-15
brightness=55

Videosource specificationvalues

Youcan use the source input field describedin Source selection controls on next page in a command
to set an absolutevalue or adjustment valuet o a sourceother than the active source. You can do this
whilet hes electedsource is inactiv e, but the sourcedevice must be connected or you will receive an
invalidcommand response.
>set brightness vga1=65
brightness vga1=65
>set brightness vga1-7
brightness vga1=58
Power state controls
Thesecommands put the projectorin and out of Standby mode andrequest the projector’scurrent
powerstate. The projector’s power state determineswhether certain commandsare availableat that
time. Theses ettings areavailable even whent heprojector is in Standby mode.
Command Response
on powerstate=[field]
off powerstate=[field]
off now powerstate=[field]
getpowerstate powerstate=[field]
This tabledescribes the power state commands.
Command Description
on Turns on the projector.
off Starts the shutdown process. A dialog box appearson the projected
imagewith t hemessage, “Press Power Button to Turn off Projector.”
Youmust senda second Off commandwi thin10 seconds to put the
projectorinto Standby mode.
off now Shuts down the projectorimmediately. You can’t delay or cancel this
command.
getpowerstate Indicatesthe projector’s currentpower state.
CH A P T E R 8
Connectingyour room control system toyour intera ctiveprojector
63