Network controls
Thesecommands inform you of the currentnetwork settings.
Command Response
getnetstatus netstatus=connected
netstatus=disconnected
netstatus=disabled
getdhcp dhcp=[current DHCP status]
getipaddr ipaddr=[currentIP address]
gets ubnetmask subnetmask=[currentsubnet mask number]
getgateway gateway=[currentnetwork gateway]
getprimarydns primarydns=[currentprimary domains erver]
getmacaddr macaddr=[currentMAC address]
Thesecommands control your networks ettings.
Command Command targetrange Response
set dhcp [target] =on
=off
dhcp=[current]
set ipaddr[target] =0.0.0.0 to =255.255.255.255 ipaddr=[current]
set subnetmask [target] =0.0.0.0 to =255.255.255.255 subnetmask=[current]
set gateway [target] =0.0.0.0 to =255.255.255.255 gateway=[c urrent]
set primarydns[target] =0.0.0.0 to =255.255.255.255 primarydns=[current]
System controls
Thesecommands enableyou to s witch system s ettings andaccess system information.
Thesecommands inform you of the currentsy stem settings. These commands areunavailablew hen
theprojector is in Standby mode.
Command Response
getautosignal autosignal=[currentauto signal detection setting]
getlampreminder lampreminder=[currentlamp remindersett ing]
gethighbrightness highbrightness=[currentlamp brightnesssetting]
getautopoweroff autopoweroff=[currentauto power off setting]
getz oom z oom=[currentzoom setting]
getprojectorid projectorid=[currentprojector ID number]
gethposition hposition=[currenthorizontalposition offset s etting]
getv position vposition=[currentv erticalposition offset setting]
getaspectratio aspectratio=[current projectoraspect ratio]
CH A P T E R 8
Connectingyour room control system toyour intera ctiveprojector
70