SWITCH STATIC CONFIGURATION MENU
Configuring the IP Address
Use the IP Configuration page to configure the switch’s IP parameters.
Field Attributes
•IP Address – IP address of the switch. Valid IP addresses consist of four numbers, 0 and 255, separated by periods. Anything outside this format will not be accepted by the configuration program.
•Subnet Mask – Subnet mask of the switch. This mask identifies the host address bits used for routing to specific subnets.
•Gateway – Gateway used to pass trap messages from the system’s agent to the management station. Note that the gateway must be defined if the management station is located in a different IP segment.
Console – Click Switch Static Configuration=>Administration Configuration=> IP Configuration. Specify the IP address and other parameters. Save your changes, and then reboot the switch to enable the new settings.
TigerSwitch 10/100 : | IP Configuration |
===================== |
|
IP Address : 10.1.0.4
Subnet Mask : 255.255.255.0
Gateway : 10.1.0.253
<Edit> | <Save> | <Quit> | |
|
| Select the action menu. |
|
Arrow/TAB/BKSPC = Move Item | Quit = Previous menuu | Enter = Select Itemm | |
