WRR-855A/ 855B

Set the AUDIO IN switch (see page 161) to WIRELESS for the channel to be used.

For the operation of the WRR-855A/855B, refer to the manual supplied with the WRR-855A/855B.

Notes

•When the XLR connection automatic detection function is on, even if the AUDIO IN CH-1 or CH-2 switch is set to WIRELESS, the signal input to the AUDIO IN CH1 or CH2 connector is automatically selected when an audio cable is connected to the AUDIO IN CH1 or CH2 connector. In such a case, set REAR XLR AUTO to OFF on the AUDIO-1 page of the MAINTENANCE menu.

•The audio signals to be recorded on audio channels 3 and 4 depend on the settings of the AUDIO IN CH-3/CH-4 switches without being affected by the XLR connection automatic detection function.

Fitting the WRR-862 (Using a BP-GL65/ GL95/L60S/L80S Battery Pack)

1 (1) Attach the WRR tuner fitting (not supplied, service part number: A-8278-057-A) to the back of the camcorder.

1Use a Phillips type screwdriver to tighten the four screws placed in the tuner fitting. For three of these screws, insert the screwdriver through the corresponding hole and tighten the screw.

2Loosen the adjustment screws.

3Adjust the tuner fitting position for a BP- GL65/GL95/L60S/L80S Battery Pack to be attached, and tighten the adjustment screws to fix its position.

4Attach the mount plate supplied with the WRR-862.

(2)Attach the battery pack.

For details about attaching the BP-GL65/GL95/L60S/ M100 Battery Pack, see 9-1-1 “Using a Battery Pack” on page 154.

BP-GL65/GL95/L60S/

L80S

Adjustment screws

Mount plate

(supplied with WRR-862)

Back of

 

camcorder

Phillips type screwdriver

 

2 Mount the tuner on the WRR tuner fitting.

WRR-862

3 Connect the tuner power cord to the DC OUT connector of the camcorder, and the audio output cable to the AUDIO IN CH1 or CH2 connector.

4 Set the switches as follows.

•Set the LINE / AES/EBU / MIC switch for the channel to which the audio out cable is attached to MIC.

•When the XLR connection automatic detection function is off, set the AUDIO IN CH-1 or CH-2 switch for the channel to which the audio output cable is connected to REAR.

If the XLR connection automatic detection function is on, the input signal for audio recording is selected automatically, and therefore this setting is not required.

Camcorder the Up Setting 9 Chapter

9-5 Audio Input System 163