Playback and Recording 3 Chapter
The message “DELETING LAST CLIP” appears, and the processing for deleting the last recorded clip begins.
When the deleting has finished, the message “LAST CLIP WAS DELETED” appears.
Note
If an operation (other than recording review) which is not a retake operation is carried out after the last clip has been recorded, the retake function does not work even when the camcorder is in the recording pause state.
In this case, the message
Auto clip list recoding is a function for automatically including the clips generated by recording operations in a selected clip list. The updated clip list is saved to the disc. Proceed as follows.
| THUMBNAIL |
|
|
| SEL/SET |
| ESSENCE MARK | S.SEL |
| SUB CLIP | |
|
| |
SUB CLIP |
|
|
button | CLIP MENU | SHIFT |
| PRESET | |
| REGEN | SET |
| CLOCK |
1 Insert a disc.
2 Load a clip list from the disc.
•To create a new clip list, load a NEW FILE (empty) clip list.
•To add clips to an existing clip list, load that clip list.
Note
Always load either a new or existing clip list from disc.
For operations, see
3 Press the SUB CLIP button, turning on the sub clip indicator.
The camcorder enters auto clip list recording mode. The viewfinder screen shows the number of the clip list loaded in the current clip list.
The number of the clip list loaded in the current clip list
16:9 E0004
| 30 |
18 |
4 Press the REC START button or the VTR button on the lens to start recording, and press again to stop recording.
A clip is generated automatically from the video and audio recorded in this interval, and added as a sub clip to the the currently loaded clip list. The updated list is also written to disc automatically.
5 Repeat the process of recording and stopping until you have included all the required clips.
To change target clip lists, carry out step 2 once more to load the desired clip list into the current clip list.
To exit auto clip list coding mode
Press the SUB CLIP button, turning off the sub clip indicator.
3-2-8 Assigning User-Defined Clip
Titles Automatically 1)
1) This is supported from firmware version 1.4.
About the automatic title generation function
By default, clips on each disc are assigned names in the range C0001.MXF to C0300.MXF. For this reason, two discs can contain clips with the same names. The automatic title generation function allows you to assign titles to all of the clips on several discs, which facilitates clip management. For example, if the titles TITLE00001 to TITLE00020 are assigned to clips C0001.MXF to C0020.MXF on disc 1, then the titles TITLE00021 to
52