FILTER selector (inner knob) setting and ND filter

selection

FILTER selector (inner knob)

ND filter

setting

 

 

 

4

1/64 ND

For the PDW-510/510P:

FILTER selector setting and filter selection

FILTER selector setting

Filter selection

 

 

1

3200 K

 

 

2

5600 K + 1/8 ND

3

5600 K

 

 

4

5600 K + 1/64 ND

If the setting of the FILTER selector is changed, a message reporting the setting appears for about 3 seconds in the setting change and adjustment progress message display area of the viewfinder screen (in display mode 3).

AUTO W/B BAL switch

The switch returns to the center position, and the adjustment is executed.

During adjustment, the message “WHITE : OP” is displayed on the viewfinder screen (in display mode 2 or 3).

The white balance adjustment ends in about one second with the message shown in the following figure, and the adjustment setting is automatically stored in the memory (A or B) that was selected in step 1.

Adjustments 5 Chapter

3 Place a white test card under the same lighting conditions as for the subject to be shot and zoom up to it.

Alternatively, any white object such as a cloth or a

AWB:OK

Approximate color

Recording for Settings and

wall can be used.

The absolute minimum white area is as follows.

Rectangle centered on the screen. The lengths of the sides are 70% of the length and width of the screen.

The white object must be within the rectangle and have an area of at least 10% of the screen.

Note

Make sure there are not bright spots in the rectangle.

4 Adjust the lens iris.

Manually adjusted lens: set the iris to an appropriate setting.

Lens with automatic iris: set the automatic/manual switch on the lens to automatic.

5 Push the AUTO W/B BAL switch to WHT and then release the switch.

. K temperature of the subject

Note

If the camera has a zoom lens with an automatic iris, the iris may hunt 1) during the adjustment. To prevent this, adjust the iris gain knob (indicated as IG, IS, or S) on the lens.

For details, refer to the lens operation manual.

1)Hunting

Repeated brightening and darkening of the image, resulting from repeated response to automatic iris control.

If the automatic white balance adjustment cannot be made

If the white balance adjustment cannot be completed normally, an error message will appear for about 3 seconds on the viewfinder screen.

Possible messages are listed below.

White balance adjustment error messages

Error message

Meaning

 

 

WHITE : NG

The white video level is too low.

LOW LEVEL

Either open the lens iris or increase

 

the gain.

 

 

86 5-2 Adjusting the Black Balance and the White Balance