Turn the POWER switch on.

5-7 Setting the Thumbnail Image

When the unit is shipped from the factory, it is set up to display the first frame of a clip as the clip’s thumbnail image (see page 62). As required, you can select another frame to display as a clip’s thumbnail image.

For example, if all clips have the same image in their first frames, you can specify a frame a few seconds after the start of the clip, so that all thumbnails will not show the same image.

To select the frame to display as a clip’s thumbnail image

Proceed as follows.

1

2 Holding down the MENU knob, move the MENU ON/ OFF switch to ON.

The TOP menu appears.

3 Turn the MENU knob to move the b mark to “MAINTENANCE”.

4 Press the MENU knob.

If this is the first time the MAINTENANCE menu has been displayed, the CONTENTS page of the MAINTENANCE menu appears. If the menu has been used before, the last accessed page appears.

5 If the CONTENTS page is displayed, turn the MENU knob to move the b mark to “ESSENCE MARK”, then press the MENU knob.

If a different page is displayed, turn the MENU knob until the ESSENCE MARK page appears, then press the MENU knob to select the page.

6 Press the MENU knob, then turn it to move the b mark to “INDEX PIC.POS.”, and press the MENU knob again.

The b mark changes to a z mark, and the z mark changes to a ? mark.

?M10 ESSENCE MARK

 

TOP

SHOT

MARK

1

:

OFF

SHOT

MARK

2

:

OFF

OVER

AUDIO

LIMIT

:

OFF

GAIN

CHG. MARK

:

OFF

FILTER

CHG. MARK

:

OFF

SHUTTER

CHG. MARK:

OFF

WHITE

CHG. MARK

:

OFF

FLASH

MARK

 

:

OFF

FLASH

MARK

LEVEL

:

10

INDEX

PIC.

POS.

:?

0SEC

 

 

 

 

 

 

7 Turn the MENU knob to select the desired time.

8 Press the MENU knob.

The selection is confirmed.

9 Set the MENU ON/OFF switch to OFF to end the menu operation.

Recording for Settings and Adjustments 5 Chapter

5-7 Setting the Thumbnail Image

99