Sony PDW-510P, PDW-530, PDW-530P 10-3Operation Warnings

Maintenance 10 Chapter

10-3 Operation Warnings

When a problem occurs at power on or during operation, a							camcorder body. The speaker and earphone also give
warning is given by the relevant indicators on the color and							audible warnings.
monochrome LCDs, in the viewfinder and on the
				Operation warnings
Alarm	Indicators on color/		Indicators in viewfinder/				Warning	Problem	VDR	Action to take
Message	monochrome LCDs		on camcorder body				sounds		operation
	Warning/	Flashing/	:Continuous		:1 flash/s		:
	Battery	continuous	:4 flashes/s				4 beeps/s
	status						:
			WARNING	REC/tally		BATT
	indication						1 beep/s
							:
							Continuou
							s beep
E**-** 1)	–	–				–		Recording	Recording	Turn off the power
								error	stops.	and consult your
										Sony representative.
MEM Full	–	–	2)	2)		–	2)	Shockproo	Recording	Protect the unit from
								f memory	continuous but	shocks and vibration.
								overflow	may be
									substandard.
ILL.REC!	–	–	2)	2)		–	2)	Input sync	Recording	Turn off the power
								error	continuous but	and contact your
									may be	Sony service
									substandard.	representative. (This
										indication may be
										given momentarily
										when a GENLOCK
										signal is connected or
										disconnected, but this
										does not indicate a
										problem.)
Disc Error!	–	–	2)	2)		–	2)	A disc	Recording	If defects are
								defect was	continues,	detected repeatedly,
								detected.	avoiding the	exchange the disc.
									defect, but
									may be
									substandard.
HUMID!	–	Continuous	2)	2)			2)	Condensa-	Recording/	Stop recording/
							3)	tion on the	playback	playback, turn off the
								optical	continues but	power, then turn it on
								pickup.	stops when an	again, and wait until
									error occurs	the HUMID indicator
									on the drive.	disappears.
Before	DISC	Flashing4)	2)	2)			2)	Disc	Operation	Be prepared to
Full 8)								almost full.	continues.	change the disc.
DISC	DISC and	Flashing 5)	6)	6)			6)	Disc full.	Recording	Change the disc.
FULL! 6)	E								stops.
LOW	BATT	Flashing4)		7)			7)	Battery	Operation	Change the battery.
BATT! 8)								almost	continues. 5)
								exhausted.
BATT	BATT and	Flashing5)						Battery	Operation	Change the battery.
EMPTY!	E							exhausted.	stops.
High	–	–				–		Internal	Operation	Power the unit off and
TEMP!								temperatur	continues.	move it to a cool
								e high.		place.

174 10-3 Operation Warnings