3-3-2 Checking the Last Two

Seconds of the Recording —

Recording Review

If you press the RET button on the lens while recording is paused, the last two seconds of the recording is played back on the viewfinder screen and the color LCD. Use this

3-3-4 Thumbnail Search

Cuing up a desired clip

To display the thumbnail images of all clips on the disc, and cue up a desired clip, proceed as follows.

function to check whether recording went smoothly. If you hold down the RET button, a low-speed reverse search begins at a position two seconds before the recording end position. When you release the RET button, the reverse search stops and playback in the forward direction begins.

2,3

1

Thumbnail THUMBNAIL indicator

ESSENCE MARK

SEL/SET

After playback, the camcorder is ready to start recording again.

Sub clip SUB CLIP indicator

S.SEL

Playback and Recording 3 Chapter

By assigning the the same function as that of the RET button on the lens to the ASSIGN 1/3/4 switch, you can use the switch in the same way as the lens RET button.

For details, see 7-3-5 “Assigning Functions to ASSIGN 1/ 2/3/4 Switches” on page 133.

3-3-3 Checking the Recording on the Color Video Monitor — Playback in Color

Connect a color video monitor to the VIDEO OUT connector of the camcorder. By pressing the PLAY/ PAUSE button, you can view the recorded picture.

When the CBK-SD01 SDI Output Board is installed, you can connect a color video monitor provided with an SDI input connector.

PDW-510/510P/530/530P

Color video monitor

VIDEO IN connector 1)

SDI IN connector 2)

VIDEO OUT connector

1)When VBS is selected as the output signal of the VIDEO OUT connector

2)When SDI is selected as the output signal of the VIDEO OUT connector (only when the CBK-SD01 is installed)

Color playback

Note

You can select either VBS or SDI as the output signal of the VIDEO OUT connector when the CBK-SD01 is installed.

For details, see 7-3-2 “Selecting the Output Signals” on page 131.

CLIP MENU

SHIFT

PRESET

F-RUN

REGEN

SET

CLOCK

R-RUN

3 2

1 With the sub clip indicator off, press the THUMBNAIL button, turning on the thumbnail indicator.

The thumbnails of all clips on the disc appear.

Notes

•If the MENU ON/OFF switch is set to ON, set it to OFF and press the THUMBNAIL button.

•If you set the MENU ON/OFF to ON during thumbnail display, thumbnail display is cancelled and replaced with menu display.

62 3-3 Checking Recording and Playback