To go to the clip deletion screen without displaying the THUMBNAIL menu
After step 2, press the RESET button with the SHIFT button held down (shortcut operation).
To cancel the deletion and return to the thumbnail screen
Do one of the following.
•With “CANCEL” selected, press the SEL/SET dial or the MENU knob.
•Press the RESET button.
5 Turn the SEL/SET dial or MENU knob to select “OK”, and then press the dial or knob.
The clip is deleted and you return to the thumbnail screen.
To delete all clips
1 Carry out steps 1 and 3 of “Deleting Clips” to display the THUMBNAIL menu (see page 65).
2 Turn the SEL/SET dial or MENU knob to select “DELETE ALL CLIPS”, and then press the dial or knob.
A cofirmation screen appears.
To cancel the deletion and return to the thumbnail screen
Do one of the following.
•With “CANCEL” selected, press the SET button.
•Press the RESET button.
3 Turn the SEL/SET dial or MENU knob to select “OK”, and then press the dial or knob.
All clips are deleted, and you return to the thumbnail screen.
3-4 Recording Video
Signals From
External Equipment
With this camcorder, you can select in the OPERATION menu whether to record the video captured by the camera, or whether to record a signal from an external video device.
If this switching function is assigned to the ASSIGN 2 switch, regardless of the setting in the OPERATION menu, you can make the selection with the ASSIGN 2 switch. While you are recording a DV stream from an external DV device, the indication
Notes
•You can switch the signals to be recorded using the ASSIGN 2 switch or by a menu operation at any time while recording on the disc. However, the signals recorded at the point where the signal is switched may be distorted. If the camera/external switching function is assigned to the ASSIGN 2 switch, you cannot use the following menu operations to switch between camera and external source input.
•Even when the REC VIDEO SOURCE item is set to “EXT”, if the external video signal is not input to the i.LINK DV IN/OUT S400 connector or the GENLOCK IN connector, the camcorder does not switch to EXT mode, and the pictures being shot by the camcorder are recorded on the disc.
3-4-1 Recording a DV Stream From External Equipment
Notes
•Recording a DV stream is possible only when the video recording format is DVCAM.
If the currently set video recording format is other than DVCAM, change it to DVCAM referring to
•If i.LINK MODE is set to “FAM” on the OUTPUT page (page 180) or SOURCE SEL page (page 186) of the OPERATION menu, it is not possible to record DV streams. To record DV streams, set i.LINK MODE to “AV/C”.
Proceed as follows.
Playback and Recording 3 Chapter
67 | |
|
|