• Deletion and renaming of directories
Notes
•File names and directory names can use letters, numbers,
and symbols from the Unicode 2.0 character set. However, the following control characters and symbols 1) cannot be used.
-Control characters: U+0000 to U+001F, U+007F
-Symbols: ", *, /, :, <, >, ?, \,
1)This is supported from firmware version 1.4. However, the following character codes cannot be used by FAM connections.
U+010000, U+020000, U+030000, U+040000, U+050000, U+060000, U+070000, U+080000, U+090000, U+0A0000, U+0B0000, U+0C0000, U+0D0000, U+0E0000, U+0F0000, U+100000
(There are no limits to characters which can be used by FTP connections.)
6-2 File Access Mode File Operations
File access mode operating environmentOperating system requirements for file operations by file access mode (called FAM below) are as follows.
•Computer operating system: Microsoft Windows 2000 Service Pack 4 or higher, or Microsoft Windows XP
PreparationsDo the following on the remote computer and this unit.
•Install the FAM driver on the remote computer.
•Enable FAM connections over the i.LINK connector.
To install the FAM driver
Insert the supplied
For details, refer to the ReadMe file contained on the CD- ROM disc.
Note
Use Version 1.4 or higher of the FAM driver. The FAM driver on the supplied
To check the version, click “Add or Remove Programs”(Windows XP) or “Add/Remove Programs” (Windows 2000), select “ProDisc,” and then click “Click here for support information.”
To enable FAM connections over the i.LINK connector
Proceed as follows.
1 Set the MENU ON/OFF switch to ON.
The last accessed page appears.
2 Turn the MENU knob to scroll to the OUTPUT page, then press the MENU knob.
The OUTPUT page appears. The current settings appear on the right side of each item.
3 Move the b mark to “i.LINK MODE”, then press the MENU knob.
The b mark changes to a z mark, and the z mark changes to a ? mark.
Operations File 6 Chapter
103 | |
|
|