Stairmaster 4400 PT/CL, 4600 PT/CL, 4200 PT manual Installation Instructions, Page

INSTALLATION INSTRUCTIONS

6.Check to be sure that the input AC power rating marked on the power supply matches the available power. If it does not, obtain the match- ing power supply from StairMaster® Health & Fitness Products, Inc. before proceeding any further.

!WARNING

TO REDUCE THE RISK OF ELECTRICAL SHOCK AND FIRE AND TO

PREVENT SEVERE DAMAGE TO THE MACHINE, USE ONLY THE POWER SUPPLY APPROVED FOR USE WITH THIS EQUIPMENT. IN ADDITION,

YOUR MACHINE MUST BE PROPERLY GROUNDED.

7.Connect the AC power cord to the AC wall outlet. Refer to the “Grounding Instructions” section if the AC wall outlet does not accept athree-prong plug.

8.Watch the console. The 4600/4400 PT should display a software revision code and then show “SELECT WORKOUT.” The 4200 PT console should run through a self test and then display a moving line in the upper LCD window. If the console does not, unplug the power supply and then plug it back in. If the console still does not power up correctly, contact our Customer Service Department. Refer to the Appendix for the appropriate phone number.

9.If you have a 4600/4400 CL, step on the pedals to check for proper operation. Once you step on the pedals, the console should display a software revision code and then show “SELECT WORKOUT.” If it does not, connect the battery charger to the connector on the lower left side. If the console still does not power up contact our Customer Service Department. Refer to the Appendix for the appropriate phone number.

10.The display “SELECT WORKOUT” tells you the machine is ready to use. The 4600/4400 PT/CL console displays this message and the 4200 PT displays a moving line in the upper LCD window when the console is ready to use.

Page 8