Finishing Setup: Setting Up Passwords

You can set up passwords for two levels of security: for operators and for setup personnel. The controller comes from the factory with neither password set. This allows every user access to all functions.

Setup Password. If you define a password for setup personnel, then most settings can be changed only after entering the password. The password will be required to display the following screens:

System Setup (to review and change system-wide settings and go to the network status screens)

Station Setup (to review and change settings for all station options)

Pump Setup (to review and change settings for all pump options)

Operator Password. If you define a password for operators, then a password will be required to carry out any function (other than reviewing station and pump status, silencing alarms, reviewing the alarm log, and looking at help screens). Entering the operator’s password will give the user access to the functions at the following screens:

Station Status (to enable or disable a station, and start or stop system)

Pump Status (to enable or disable a pump, and start or stop system)

Station n Operator (to adjust a station’s convey time and dump delay, activate priority convey, and review the station’s last convey time and pump assignment; depending on the options installed, the screen may also enable the operator to adjust the mixture percentage for a remote proportioning valve, change the purge time and purge valve, and set the intended material line for manifold sharing)

Entering the setup password will give the user access to all functions.

To set (or remove) password protections:

1.Press System Setup on the right side of the screen to go to the System Setup screen if needed.

The System Setup screen appears:

The current passwords are displayed under Operator Password and Setup Password. No value means that no password is required.

24-Pump, 128-Station Controller

Chapter 3: Installation

48

Page 49
Image 49
Sterling 882.00255.00 CV3-655 specifications Finishing Setup Setting Up Passwords