3.Run the cables from the remote interface(s) to the switch and the main controller, neatly dressing the cable with ties so that it does not interfere with system operation and it gives a neat appearance.

4.Attach RJ45 connectors at each cable end following the connector manufacturers instructions.

5.The “Ethernet out” connection on the main controller should connect to the “Ethernet in” connection on the switch.

6.The “Ethernet out” connections on the switch should connect to the “Ethernet in” connections on the main controller and the remote interface(s).

24-Pump, 128-Station Controller

Chapter 3: Installation

22

Page 23
Image 23
Sterling 882.00255.00 CV3-655 specifications