Sterling 882.00255.00 CV3-655 specifications Name Description Options Default Conveying Options

Name	Description	Options	Default
Conveying Options
Assigned to pump n	Name of the pump to which this station’s
	vacuum line is connected.
Special convey	When this option is enabled, the station’s	disabled,	disabled
	vacuum valve remains open for the convey	enabled
	time, even if the station is not demanding
	material and is indicating that it is full. When
	disabled, the station’s vacuum valve opens
	when there is demand from the station, and it
	remains open until the convey time has elapsed
	or material trips the volume-fill proximity switch.
	Enable this option if and only if the station has
	no flapper.
Closed Loop	This option allows material to be conveyed and
	processed without being contaminated by
	outside influence (such as dust, other materials,
	etc.)
Alarm Options
No convey	When this option is enabled, the controller	disabled,	disabled
	issues a “no convey” alarm if it has repeatedly	enabled
	attempted to convey material to the station but
	the flapper never opened during the dump
	delay. (The number of attempts is controlled by
	the next setting.)
	Usually this option should be enabled. At times,
	you may wish to disable it during operation as a
	stopgap measure for dealing with an alarm.
# attempts B4 alarm	Number of attempts before alarm: the number of	1–99	3
	times the controller will attempt to convey
	material to a station before it issues a “no
	convey” alarm.
	The setting for this option depends on (a) how
	much material your mold uses to make each
	part compared with the capacity of the receiver
	and (b) how important it is to keep your mold
	from running out of material and shutting down.
	A higher setting will give you fewer alarms, at
	the risk of emptying the receiver without
	warning. A lower setting will give more frequent
	alarms, at the risk of disrupting operations
	unnecessarily.

24-Pump, 128-Station Controller Chapter 6: Configurable Settings 65