For daily use

Switching on and off

>Switch the digital receiver on by pressing the On/Stand-bykey either on the receiver or on the remote control.

>Press this key again to switch the receiver off again.

>The receiver is now in stand-by mode, the current time will be shown in the display.

Programme selection

Using the programme up/down keys

>Use the Programme keys up/down either on the receiver or on the remote control to move up or down by one position in the programme list.

Using the numeric keys

>Use the numeric keys to enter the desired pro-

 

gramme number. For example

1

 

 

for programme slot 1

1,

then 4

 

for programme slot 14

2,

then 3, then 4

 

for programme slot 234

1,

then 5, then 6

then 7

for programme slot 1567

When entering programme numbers consisting of several digits, you have approx. 3 seconds time after pressing a key to complete the entry.

If you wish to enter a number consisting of only one, two or three digits, hold down the key for the last digit a little longer to speed up the switching procedure.

Using the programme list

>Press the OK key.

>You can now mark the desired programme using the arrow keys up/down.

>Press the OK key to switch to the programme selec- ted.

>Use the arrow keys up/down to move the marker around the list one line at a time.

>Use the arrow keys left/right to move through the list one page at a time.

Volume control

>Adjust the volume of your digital receiver by using the keys Volume + to increase the volume resp. Volume - to decrease the volume.

>Press the Sound on/off key to switch the sound on or off (mute).

112

080206

2233520000100

 

Page 112
Image 112
TechniSat DigiCorder S2 manual For daily use, Switching on and off, Programme selection Using the programme up/down keys