Deleting the SFI timer event
>If you would like to delete a timer event programmed by means of the SFI, proceed as described above for marking the appropriate programme.
>Press the red function key Timer to open a selection window.
>Use the arrow keys up/down to mark the line
Delete timer.
>Confirm by pressing OK.
Timer settings (pre- and post-run time)
In the case of SFI timer programming, the receiver obtains the data related to the selected programme automatically from the SFI data. Both the starting and the ending time of the programme will be taken over correct to the nearest minute. However, it frequently happens that the selected pro- gramme starts a little earlier or a little later than scheduled. In this case the start or the end of the programme may be mis- sing from the recording. To overcome this problem, you can enter a pre- or
>Press the red function key Timer to open a selection window.
>Use the arrow keys up/down to mark the line Timer settings.
>Confirm by pressing OK. A menu will be displayed, allowing you to enter the
(Fig.
>Now use the arrow keys up/down to mark the line
Timer pre-run time resp. Timer post-run time.
>Use the numeric keys to enter the desired pre- or
>Press the green function key Accept, to store the setting, and to return to the previous SFI table.
7.15.7.3SFI programme overview
You can use the SFI programme overview to display a table with the whole day’s programme of a single channel. To do this, proceed as follows:
>Press the SFI key. If you have selected the start cate- gory Overview, see Point 9.2.3, the SFI table „Now“ will be displayed.
>Press the blue function key SFI Menu.
41
