Tektronix PHASER 380 manual 9662-29

Caring for Your Printer 5

3.Grasp the maintenance tray by the front handle and lift up while sliding it out of the printer.

9662-29

You may notice an accumulation of ink, paper dust and drum ßuid on the maintenance tray blade of a used maintenance tray. These deposits are normal and do not affect its operation. Refer to ÒCleaning the maintenance tray blade (optional)Ó on page 5-49 for more information.

Note Once the maintenance tray has been partially used, it leaks drum ßuid if tipped. Never ship a partially used maintenance tray. Contact with the waste ink and drum ßuid poses no known health risk, but can permanently stain clothing. Refer to ÒMSDS for silicone oilÓ on page 9-6 for more information.

4.Install a new maintenance tray in the printer.

5.Close the front cover and wait for the printer to warm-up.

6.To prevent leaking, seal the used maintenance tray in the plastic bag from the new (replacement) maintenance tray. Treat the used maintenance tray as normal ofÞce waste.

Note When you install a new maintenance tray in the printer, the printer enters a warm-up cycle lasting approximately 20 minutes. Noises during the warm-up cycle are normal and not an indication of problems with the printer.

User Manual 5-9