Tektronix PHASER 380 manual Installing the maintenance tray

Getting Set Up 2

Installing the maintenance tray

The printer is shipped with a maintenance tray that must be installed before printing is possible. The front panel displays a message indicating when the maintenance tray is low, allowing you to make a limited number of prints before the tray is depleted. To avoid printing delays, always keep an extra maintenance tray available. When you reorder a replacement maintenance tray for the printer, use Tektronix order number 436-0303-00.

Note There is a 20-minute warm-up period required after installing a new maintenance tray. As the printer initializes, it cycles the new maintenance tray to prepare it for use. Noises during the warm-up period are normal and are not an indication of a problem.

1.Open the front cover.

9662-07

2.Open the maintenance tray shipping box and remove the maintenance tray. Refer to ÒReplacing the media tray separator padÓ on page 5-10 for directions on using the replacement separator pad included with each maintenance tray.

User Manual 2-11