Telenetics 56 manual Connecting the Cables, Telco/Dial Line Telephone, Set Connector Power Input

Connecting the Cables

1.Turn off your computer.

2.Plug the data cable's male end (pins showing) into the connector marked RS232 at the back of your Modem and then plug the female end (no pins showing) of the same cable into the COM port at the back of your computer.

3.Your computer's COM port could be 9 pins or 25 pins. Use the appropriate connector on the cable suppled to conntect your Modem to your Serial port.

4.Plug the telephone cable into the connector marked LINE at the back of your Modem and the other end of the cable into your telephone wall socket.

☞Your Modem has a Telephone Set connector to allow 4-wire leased-line operation. Refer to the section on Leased Line Operations for details on this feature.

5.Plug the power cable pin into the POWER connector at the back of your Modem and plug the power supply into a suitable power point.

6.Use the ON/OFF switch to turn on your Modem. Then check that some of the Modem lights illuminate.

7.Restart your computer.

8.Now you need to install your Modem's Driver. Which operating system is your computer running? Read the next section for driver installation instructions.

Telco/Dial Line

Telephone	DTE RS232	Low Voltage
Set	Connector	Power Input

ON/OFF

Page 12