Accessing a System Using SuperSecure
If both your modem and the remote modem have been correctly setup you can: q Dial the remote system.
❑The modems will connect and enter security dialog mode using the modem’s primary key.
❑This key must be the same for both modems.
•Enter your username
•Press ENTER
•Enter your user password stored in the remote modem then ‘/’
•Enter your password stored in your modem
•Press ENTER
☞You may backspace to correct errors but you will not be able to see what is typed since all characters are echoed as #
•Do not use the / character in any password
•If the password is the same on both modems then only one password needs to be entered
Connection
❑You will then CONNECT if the username, both passwords, all of the KEYS, IVs and KEs match.
❑The data will be correct and error free, but encrypted on the line using a KEY unknown to anyone.
Disconnection
❑If the primary DES KEY mis matches you will not be able to read the “username” prompt.
❑The modems will disconnect if:
•The secondary key, IV or KE mismatches (you will also receive a message)
•An error corrected link cannot be established
•Wrong username and/or password is used. You will be given another two chances to enter them before the modem disconnects
Example:
ATDT 456 4321
RINGING
RINGING
Enter name: MarkStein
Enter password: Fudge/Vanilla
Access granted
Page 44
