AT%R CTS Override

The %R command allows you to determine the state of the CTS signal.

This command is intended to replace the CTS switch if your modem does not have one (eg Pocket & Rack Modems) This command overrides any &R setting.

The %R command does not revert to the default setting after an ATZ, AT&F or modem power off is performed.

Options

AT%R0

&R command determines the state of CTS

AT%R1

CTS always follows RTS (both in on-line state and local command state)

AT%R2

V.25bis mode: CTS on when ready to accept a command

See Also

&R

Sync RTS/CTS control

S Register 26

RTS/CTS Delay

Range

 

0-2

 

Page 162

Page 162
Image 162
Telenetics 56 manual AT%R CTS Override, AT%R1, AT%R2