Starting the computer by password

Starting the computer by password

To start up the computer with the user password, follow these steps:

1.Turn on the power as described in Chapter 3, Getting Started. The following message appears:

Password =

NOTE: At this point, the hotkeys Fn + F1 to F5 do not work. They will function after you enter the password.

2.Enter the password.

3.Press Enter.

NOTE: If you enter the password incorrectly three times in a row, the computer shuts off. In this case, you must turn the computer back on to retry password entry.

Power-up modes

The computer has the following power-up modes:

❑Boot: Computer shuts down without saving data. Always save your work before you turn the computer off in boot mode.

❑Hibernation: Data in memory is saved to the hard disk.

❑Standby: Data is maintained in the computer’s main memory.

NOTE: Refer also to the sections Turning on the power and Turning off the power in Chapter 3, Getting Started.

Windows utilities

You can specify the setting in TOSHIBA Power Saver.

Hot keys

You can use hot keys Fn + F3 to enter Standby mode and Fn + F4 to enter Hibernation. See Chapter 5, The Keyboard for details.

POWER -U PM ODES

OWERP AND

6-15